Variable speed pool pump installed at a Tucson equipment pad

Pool Pump Repair and Replacement in Tucson

Pumps that hum, scream, leak, overheat or will not prime. We repair them when a repair makes sense and replace them with an efficient variable speed pump when it does not.

Get My Free EstimateCall (520) 555-0163
  • Repair or replace, explained honestly
  • Common parts carried on the truck
  • Variable speed pumps sized to your pool
  • Run schedule set for Tucson seasons
Pool pump with its lid open during a repair

The pump is the heart of the pool, and Tucson works it hard

A pool pump runs for hours every day, and in a Tucson summer it runs longer than almost anywhere else, because warm water needs more filtration to stay clear. It sits on a pad in full sun, often well past a hundred degrees on the surface, pulling water through a filter that monsoon dust keeps loading up. That combination is why pumps here wear out seals, bearings and motors faster than the box suggests.

The good news is that most pump problems are fixable. A pump that will not prime usually has an air leak at the lid or a suction fitting. A screaming pump usually needs bearings. A pump that hums and will not start often needs a capacitor. A drip under the pump is usually a shaft seal. Those are common repairs.

Sometimes the honest answer is replacement. An old single speed pump with a failing motor is often a good moment to switch to a variable speed pump, which can run slower and quieter for most of the day and use far less electricity. We explain both options and let you choose.

Pump problems we fix

Will not prime or loses prime

Air leaks at the lid, a cracked strainer housing, a dry O-ring, a leaking suction valve or a low water level. We find where the air gets in and seal it.

Noise, heat and failure to start

Screaming or grinding bearings, a humming motor that will not turn over, a pump that trips the breaker or shuts off when hot. Usually bearings, a capacitor or a motor near the end of its life.

Leaks and worn seals

Water dripping from under the pump, around the shaft or at the unions. A failed shaft seal lets water into the motor if it is left alone, so it is worth fixing early.

What a pump visit includes

Diagnosis under load

We run the pump, listen to it, check amperage where needed, look at the basket and lid, and trace any air or water leaks on the suction and pressure sides.

Repair options

Seals, O-rings, lids, baskets, bearings, capacitors and motors repaired or replaced, with the price agreed before we start.

Replacement when it makes sense

A properly sized pump, new unions and plumbing where the old connections are worn, and the electrical connection made to the existing circuit.

Run schedule set up

Speeds and hours set for the season, longer in summer and shorter in winter, so the water stays clear without wasting power.

Old pool pump motor removed for replacement

How pump repair works

  1. Tell us what it is doing

    Humming, screaming, leaking, not priming, tripping the breaker or simply not running. The more you can tell us, the faster we find it.

  2. Diagnose on site

    We run the system, check for air and water leaks and test the motor.

  3. Repair or replace, your call

    You get the price for the repair and, where it makes sense, for a replacement, with an honest view on which one we would pick.

  4. The work

    Common repairs are usually done on the first visit. Replacement pumps are installed with fresh unions and the plumbing checked.

  5. Prime and test

    We prime the pump, check flow and pressure, and watch for leaks with the system running.

  6. Schedule the season

    We set the run times for the time of year and adjust them as the weather changes if you are on weekly service.

Why Tucson owners trust us with their pump

We fix first when fixing is right. A worn seal or a failed capacitor is not a reason to buy a new pump, and we will not treat it like one.

We know what kills pumps here. Heat on the pad, long summer run times, dirty filters and low water from evaporation all show up in the repairs we do. We fix the pump and tell you what caused the problem so it does not come back.

And we size replacements properly. A pump that is too big for the plumbing wastes power and stresses the filter. We match the pump to the pool and the equipment around it.

Pump making noise or not running?

Tell us what it is doing. We will diagnose it and give you a straight price for the repair, or for a replacement if that is the better call.

Get My Free Estimate Call (520) 555-0163

Pool pump questions

Is there a reset button on a pool pump motor?

Some motors have a thermal overload that resets on its own once the motor cools, and some timers and automation systems have their own reset. If the pump keeps shutting off, especially on hot afternoons, that is a sign of a problem such as failing bearings, poor ventilation around the motor or a clogged basket. Resetting it again and again does not fix the cause. Switch it off at the breaker and call us.

What ruins a pool pump?

Running dry is the big one, from low water after evaporation, a clogged skimmer or a closed valve. Heat and poor ventilation, a filter that has not been cleaned, a leaking shaft seal that lets water into the motor, and debris getting past the basket all shorten its life. Most of that is preventable with weekly service.

Are pool pumps worth repairing?

Often, yes. Seals, O-rings, lids, capacitors and bearings are normal wear parts and much cheaper than a new pump. When the motor itself has failed on an older single speed pump, replacement with a variable speed pump usually makes more sense, because the energy savings help pay for it. We give you both prices and our honest recommendation.

What is the typical cost of replacing a pool pump?

It depends on the size and type of pump, whether the plumbing at the pad needs to be changed to fit it, and the electrical connection. A variable speed pump costs more up front than a single speed pump and costs less to run. We give you a written price before anything is ordered.

How much does it cost to maintain a pool in Arizona?

The pump is a large part of the answer, because it runs every day and longer in summer. A variable speed pump on a sensible schedule, a clean filter and balanced water keep running costs down. Weekly service is a separate, flat rate that we quote after the first visit.

Where we repair pool pumps

We repair and replace pool pumps across Tucson, Oro Valley, Marana, Catalina Foothills, Vail, Sahuarita, Green Valley, SaddleBrooke, Casas Adobes and Rita Ranch.

Every area we cover

Related pool services

Technician tightening a plumbing union at a pool equipment pad

Pool Repair

Diagnosis and repair for the problems that stop a pool working: no flow, air in the lines, leaks at the pad, tripped breakers and failed parts.

Cartridge pool filter being rinsed with a hose

Pool Filter Cleaning

Cartridge and DE filters taken apart, cleaned, inspected and put back, so the pump is not fighting a clogged filter through the heat and dust.

Technician checking a pool heater at an equipment pad

Pool Equipment and Heater Repair

Heaters, heat pumps, salt cells, timers, automation, valves and plumbing at the pad, repaired or replaced and set up to run efficiently.

Technician skimming leaves from a Tucson pool with a leaf net

Weekly Pool Cleaning Service

The same technician on the same day every week: skimming, brushing, vacuuming, baskets emptied, water tested and balanced for Tucson hard water.

Get your pool pump fixed

Tell us what your pump is doing. We will call to set up a visit, diagnose it and give you the price before any work starts.

Type of property

What is going on with the pool? Green water, a noisy pump, a leak at the equipment, or just looking for weekly service.

Free and no obligation. Prefer to talk? Call (520) 555-0163.